1)Original Factory Unpainted Handle Shown
	2) Remove 2 Phillips Head Screws From Door Pocket Handle
	3) Remove Phillips Head Screw From Trim Around Interior Pull Handle
	4) Remove Switch Assembly From Door Panel    (Remove Small Pocket On Manual Window Model)
	5) Unplug Wiring Harness From Switches
	6) Remove Trim Around Interior Door Handle Pull.    Remove Mirror Screw Cover Trim Panel.    (For Manual Windows Remove Window Crank)
	7) Remove Door Panel By Locating The Plastic Clips Near The Outer Edge Of The Panel. A Firm Tug Should Start To Remove The Panel. Pull Until All Clips Are Out. Lift Panel Straight Up And Out Towards The Window.
	8) Locate Black Plastic Circular Cover Near The Edge Of The Door Shell. Remove This Cover. Through This Hole Remove 10mm Nut That Holds The Handle On. Remove Other 10mm Nut On Opposite Side Of The Handle. Unclip And Remove Lock And Handle Rods At This Time.
	9) Remove Door Handle From Door Shell
	10) Remove Lock Cylinder From Stock Handle
	11) Install Original Lock Cylinder From Stock Handle Into The Painted Handle
	12) Fit Painted Door Handle Into Shell
	13) Reinstall 10mm Nuts That Hold The Handle In. To Reassemble Door Trim And Hardware Reverse Steps Starting With 12. All Other Doors Are Basically The Same Without The Key Lock Swap.